来源:/ 发布时间:2024-06-10
激光切割铝板的切面像切其他材质一样光滑吗?铝板切口一样也是光滑的,铝板只是高反光材料,需要大的激光发生器,切割气体同其他材料一样,都是用氮气切割,不会造成表面不光滑的。
Is the cut surface of laser cutting aluminum plate as smooth as cutting other materials? The cutting edge of the aluminum plate is also smooth. The aluminum plate is only a highly reflective material and requires a large laser generator. The cutting gas, like other materials, is cut with nitrogen gas, which will not cause surface roughness.
铝板采用激光切割特点:
Aluminum plate adopts laser cutting characteristics:
1、切割缝细:激光切割铝板的割缝一般在0.1mm-0.2mm
1. Cutting seam fine: The laser cutting seam of aluminum plate is generally between 0.1mm-0.2mm
2、切割面光滑:激光切割铝板的切割面无毛刺无挂渣。
2. Smooth cutting surface: The cutting surface of the laser cut aluminum plate is free of burrs and slag.
3、热变形小:激光加工的激光割缝细、速度快、能量集中,因此传到被切割材料上的热量小,引起材料的变形也非常小。
3. Small thermal deformation: The laser cutting of laser processing is fine, fast, and energy is concentrated, so the heat transmitted to the cut material is small, causing very little deformation of the material.
4、节省材料:激光加工采用电脑编程,激光设备可以把不同形状的铝板加工件进行材料的套裁,提高铝板的材料利用率,节省大量的材料成本。
4. Material saving: Laser processing uses computer programming, and laser equipment can perform material nesting on aluminum plates of different shapes, improving the material utilization rate of aluminum plates and saving a lot of material costs.
5、能切多厚铝板主要看激光发生器的功率,一般6000W的最厚能切到16mm,4500W能切到12mm。
5. The thickness of aluminum plate that can be cut mainly depends on the power of the laser generator. Generally, the thickest aluminum plate can be cut to 16mm for 6000W, and 12mm for 4500W.